Close
You have no items in your shopping cart.
Search
Picture for category Marine Wiring Devices

Marine Wiring Devices

3 Items in Grid 4 Items in Grid List

50 Amp Male/Female Weatherproof Boots

17701, & 17701-BU

This weatherproof boot is designed to work for both 50A male plugs and female connectors to provide protection against the elements.


Limited one year warranty

Call for pricing

50A Replacement Threaded Ring

17750

This 50A threaded ring can be attached to a weatherproof boot as a replacement if one breaks or strips. This ring is made of high impact ABS plastic and fits snugly over the weatherproof boot by using a heat gun or hair dryer to warm it up.

Call for pricing

30A Replacement Threaded Ring

17751

This threaded ring is compatible with most 30A RV and marine inlets. It fits over a weatherproof boot and screws over an inlet to provide maximum protection against the elements.


*Please note that a heat gun or similar device will be required when using as a replacement on a power cord.

Call for pricing

30A Collar & Threaded Ring

17760

This sealing collar and threaded ring combo bridge the gap between two 30A power cords to prevent water damage. Another 30A power cord with a weatherproof boot and ring will fit on the other side, keeping the connection safe from the elements.


*Please note that a heat gun or similar device will be required when using as a replacement on a power cord.

Call for pricing

50A Sealing Collar & Ring Combo

17761
The threaded ring and sealing collar are designed for use with 50A power cords commonly used with RVs, generators, marine shore power, etc. The threaded ring is attached to either the male plug or female connector side of the cord and securely screws around the sealing collar to offer maximum protection from water damage.
Call for pricing

L5-30P Assembly Plugs

60311, & 60311-YW

These 30 amp NEMA L5-30 locking assembly plugs can be used to wire a new cord or replace a plug with the same configuration. It comes in either a black or yellow nylon body with a rear cord clamp for easy wiring.


•Bladed Grab Cord Type


Max Grip Cable: OD ø16.5mm

Limited one year warranty

Call for pricing

L5-30R Assembly Connector

60411

This 3-prong locking connector is commonly used with RV, marine, and generator applications. It can be used to replace a connector that has the NEMA L5-30R configuration. The connector is made with a black nylon body that is resistant to impact.


•Hexagonal Cable Clamp


Max Grip Cable: OD ø16.5mm

Limited one year warranty

Call for pricing

SS1-50P Assembly Plug

60713

This 50A 125V locking assembly plug is steel encased with a yellow body. It has the NEMA SS1-50 configuration that is typically used at older marine shore pedestals.


Limited one year warranty

Call for pricing

SS1-50R Assembly Connector

60715

This NEMA SS1-50R assembly connector can be used for wiring a new cord or as a replacement for an existing power cord. The SS1-50 configuration is typically found at marine docks with older 125V pedestals.


Limited one year warranty

Call for pricing